Flap control RX1 / CB1 Electric

For free activation of the exhaust flaps in retrofitted flap exhaust systems.

• Compatibility:

Regardless of the vehicle, this control is compatible with all retrofitted exhaust systems that have electrically controlled exhaust flaps and are supplied with an ASR CB1 flap control from the manufacturer.

With this control you have the possibility to control your exhaust flaps independently of speed ranges or the driving profile selection. The module is operated via a hand-held transmitter. You have full control over the volume of your vehicle at all times.

• Benefits of the controller:

• Control independent of Drive Select
  • You decide on the vehicle sound and not the inserted driving profile
• Correct series mode (module deactivated) even after vehicle start
  • Important for visits to the workshop, service or TÜV.
    
• Freely programmable start mode
  • You decide yourself about the sound when the vehicle starts
• No intervention in the CAN bus
  • No danger to other control units
  • No influence of software updates on the function of our control
• Plug and play with original plugs
  • No damage to the original cables, no use by electricity thieves

The device offers the following modes:

start mode

The start mode describes the mode in which the device should start after the ignition is switched on. In the standard configuration, the device saves the mode last set and restores it when the vehicle starts. If you want a specific starting mode, regardless of how you parked your vehicle, this can be programmed.

The start mode can be freely programmed as desired

Last state: Press the "Sport Mode" button 5 times within 5 seconds.

Other modes: Press the button for the mode you want to learn as the start mode for about 10 seconds.

The flaps open and close 5 times to confirm successful programming of the start mode.

Assembly

• Installation is plug & play. The controller can be connected directly to the CB1 controller.

More properties 

• Can be retrofitted at any time without any traces

• Independent system without intervention in the CAN bus

• No error message

remote control

• High-quality and noble optics
• brushed stainless steel front
• Long range

Rely on our quality!

Branded product Made in Germany!

Hints

• No approval in the StVO
• For racing use only
• When driving at full throttle, the flaps should not be completely closed
• Installation at your own risk
• If the instructions are disregarded, no liability will be assumed for any damage incurred

Electronic devices and batteries must not be disposed of with household waste. Please note our information on disposal. "Notes ElektroG / BattG"