• Reduced price
Flap control RX1
  • Flap control RX1
  • Flap control RX1
  • Flap control RX1
  • Flap control RX1
  • Flap control RX1
  • Flap control RX1

Audi RS3 8Y - flap control RX2 (SSA)

439,00 €
379,00 € Save 60,00 €
Tax included including 19% VAT, plus shipping costs, the final tax rate will be calculated based on the delivery address

Flap control RX2 with control via the SSA button including memory function and vehicle-specific cable set for the following models:

  • Audi RS3 8Y
extension
Left / right hand drive
Quantity
Artikel bestellbar, Versandzeit 1-5 Werktage

Flap control RX2 with control via the SSA button including memory function and vehicle-specific cable set for installation in the footwell.

 

Compatible Models:

  • Audi RS3 8Y

With this control unit you have the possibility to switch your exhaust flaps manually. You get full control over your vehicle sound! Control is by default using a hand-held transmitter.

In addition, the system can be connected to the original SSA button via an extension. This allows you to control the exhaust flaps and the start-stop function with one button. In addition, the module has an SSA memory and restores the SSA status when the vehicle starts.

Functional description in the video:

Advantages compared to competing products

  • Control independent of Drive Select
    • You decide on the vehicle sound and not the inserted driving profile
  • Correct series mode (module deactivated) even after vehicle start
    • Important for visits to the workshop, service or TÜV.
  • workshop mode
    • Module can be completely deactivated
  • Freely programmable start mode
    • You decide yourself about the sound when the vehicle starts
  • No intervention in the CAN bus
    • No danger to other control units
    • No influence of software updates on the function of our control
  • Plug and play with original plugs
    • No damage to the original cables, no use by electricity thieves

Hand transmitter with functions:

Start mode:

The start mode describes the mode in which the device should start after the ignition is switched on. In the standard configuration, the device saves the mode last set and restores it when the vehicle starts. If you want a specific starting mode, regardless of how you parked your vehicle, this can be programmed.

The start mode can be freely programmed as desired:

Last state: Press the "Sport Mode" button 5 times within 5 seconds.

Other modes: Press the button for the mode you want to learn as the start mode for about 10 seconds.

The flaps open and close 5 times to confirm successful programming of the start mode.

Assembly

  • Installation is plug and play in the footwell behind the A-pillar panel (instructions are part of the delivery).

More properties

  • Can be retrofitted at any time without any traces.
  • Independent system without intervention in the CAN bus
  • No error message

remote control

  • High-quality and noble optics
  • brushed stainless steel front
  • Long range

This device has been specially developed for use with electric flap systems and thus offers safe and permanent operation.

 

Rely on our quality!

Branded product Made in Germany!

Hints:

  • No approval in the StVO
  • For racing use only
  • When driving at full throttle, the flaps should not be completely closed
  • Installation at your own risk
  • If the instructions are disregarded, no liability will be assumed for any damage incurred

Electronic devices and batteries must not be disposed of with household waste. Please note our information on disposal. "Notes ElektroG / BattG"