• Reduced price
Flap control RX1
  • Flap control RX1
  • Flap control RX1
  • Flap control RX1
  • Flap control RX1

Audi S3 8Y - flap control RX1

349,00 €
299,00 € Save 50,00 €
Tax included including 19% VAT, plus shipping costs, the final tax rate will be calculated based on the delivery address

Flap control with vehicle-specific cable set

For installation in the driver's footwell!

  • Audi S3 8Y
Flap control hand transmitter variant:
Quantity
Artikel bestellbar, Versandzeit 1-5 Werktage

Flap control RX1 for the Audi S3 8Y

With this control unit you have the possibility to switch your exhaust flaps manually. You get full control over your vehicle sound! Control is by default using a hand-held transmitter.

Advantages compared to competing products

  • Control independent of Drive Select
    • You decide on the vehicle sound and not the inserted driving profile
  • Correct series mode (module deactivated) even after vehicle start
    • Important for visits to the workshop, service or TÜV.
  • Freely programmable start mode
    • You decide yourself about the sound when the vehicle starts
  • No intervention in the CAN bus
    • No danger to other control units
    • No influence of software updates on the function of our control
  • Plug and play with original plugs
    • No damage to the original cables, no use by electricity thieves

Hand transmitter with functions:

Start mode:

The start mode describes the mode in which the device should start after the ignition is switched on. In the standard configuration, the device saves the mode last set and restores it when the vehicle starts. If you want a specific starting mode, regardless of how you parked your vehicle, this can be programmed.

The start mode can be freely programmed as desired:

Last state: Press the "Sport Mode" button 5 times within 5 seconds.

Other modes: Press the button for the mode you want to learn as the start mode for about 10 seconds.

The flaps open and close 5 times to confirm successful programming of the start mode.

Assembly

  • Installation is plug and play in the footwell behind the A-pillar panel (instructions are part of the delivery). Assembly time approx. 30-45 minutes.

More properties

  • Can be retrofitted at any time without any traces.
  • Independent system without intervention in the CAN bus
  • No error message

remote control

  • High-quality and noble optics
  • brushed stainless steel front
  • Long range

This device has been specially developed for use with electric flap systems and thus offers safe and permanent operation.

 

Rely on our quality!

Branded product Made in Germany!

Hints:

  • No approval in the StVO
  • For racing use only
  • When driving at full throttle, the flaps should not be completely closed
  • Installation at your own risk
  • If the instructions are disregarded, no liability will be assumed for any damage incurred

Electronic devices and batteries must not be disposed of with household waste. Please note our information on disposal. "Notes ElektroG / BattG"